MicroFlow Touch blowing machine

MicroFlow Touch fiber blowing machine is designed to answer the FTTH network needs

Compatible with 0,8 to 6,5mm cable diameter
Micro duct diameter 4 to 16mm
Preparation time : 5 min
Blowing distance : Upd to 2 500m
Blowing speed up to 90m/min
Electronic control unit
Electronic meter speed/counter with presetting of blowing distance
Adjustable motor torque load of fiber cable
Electronic protection technology to prevent damages to fiber cable

MAJOR IMPORTER OF TELECOM EQUIPMENT

Distributor in France and in 20 African countries

OFFICIAL FUJIKURA IMPORTER

Distributor of Fujikura splicers for over 25 years

VIAVI ELITE DISTRIBUTOR

Distributor partner of VIAVI for over 15 years

Microflow has a unique protection technology that stops the machine if the fiber cable meets an obstacle. The stop occurs because the cable gets bent inside the blowingmachine, this is registered by a sensor and the motor stops. The machine will also stop automatically if the motor exceeds the preset maximum torque level. In both cases the machine stops immediately so the fiber cable does not get damaged.
After the protection technology has stopped the machine, it will automatically start up again. It will try 3 times total to get through the obstacle, if it still has not succeeded it will come to a full stop.

Microflow’s control unit has a user friendly touch display, which can be used to make a number of different adjustments. You can adjust the maximum motor torque, the maximum speed, presetting of counter with automatic
stop after a certain blowing distance, adjsut acceleration - from start to maximum speed, adjust deceleration - from maximum speed to stop.

Reference

Data sheet

Type of use: Indoor FTTH network
Reachable blowing distance: up to 2,5 km
Compatible cable diameter: 0,8 to 6,5 mm
Compatible tube diameter: 4 to 16 mm
Retubing possibility: No
Dimensions (L x H xP): Blowing machine 250 x 150 x 220 mm / Control unit 250 x 160 x 130 mm
Weight: 11,7 kg
Power source: 110 - 240 V